ADVISE
&
TRICKS
To enhance the insulating and structural characteristics of the MA TERRE PREMIERE topcoat and to give a natural and rustic traditional looking walls Add one or two dry linen glitter pots for one finishing clay plaster bucket.
Humidity and clay: Our clay plasters work beautifully in a bathroom with a shower. Our plasters naturally absorb moisture from the air and later releases it back as the air dries out (humidity buffering).
The plaster will be fine everywhere except inside the shower unit where it will be exposed to water contact continuously
Areas above the shower, near the shower, or the backsplash behind the sink are fine when plastered with our plasters.
If the wall is damage by a shock or dirt the walls can be cleaned and repaired by using a damp tile sponge to remove a micro-layer of material from the surface. The damaged area should return to normal after doing this small sponging step.
"PROFESSIONNEL" toll pack contain seven important tools needed if you have no tools at home.
This pack contain:
- A stainless trowel
- A plastic trowel
- A stainless plaster trowel 8 cm
- A Big plastic trowel
- A sponge
- A mixer
- A water atomizer
TOOL PACK " PROFESSIONNEL"
The "ESSENTIEL" tool pack is the perfect compromise to apply our clay plasters.
Ce pack is useful when you already have some tools at home.
This pack contain:
- A stainless stell trowel
- A plastic trowel
- A stainless plaster trowel 8 cm
TOOL PACK " ESSENTIELS"
*Information sur le niveau d’émission de substances volatiles dans l’air intérieur, présentant un risque de toxicité par inhalation, sur une échelle de classe allant de A+ (très faibles émissions) à C (fortes émissions).
Armature for clay basecoat plasters.
Ready to use.
Shelf life: illimited
BURLAP FLAP
Armature for clay basecoat plasters
Fiberglass mesh (9mmx9mm).
Ready to use.
Shelf life: illimited
FIBERGLASS MESH
*Information sur le niveau d’émission de substances volatiles dans l’air intérieur, présentant un risque de toxicité par inhalation, sur une échelle de classe allant de A+ (très faibles émissions) à C (fortes émissions).
It is suitable for internal use as base for plastering walls and ceilings.
It can be used against a solid background or over studs or joists as a practical alternative to lining material to gypsum plasterboard and lath-and-plaster.
It is suited to using with our clay plasters in building restoration or new-build.
Ready to use
It is made from natural reed laid parallel and bound using zinc-plated narrow gauge wire to form a long sheet.
REED MATS
*Information sur le niveau d’émission de substances volatiles dans l’air intérieur, présentant un risque de toxicité par inhalation, sur une échelle de classe allant de A+ (très faibles émissions) à C (fortes émissions).
Flax Straw (100%) is a natural and non-allergenic plant fiber that enhances the insulating and structural characteristics of the MA TERRE PREMIERE topcoat .
It gives a natural and rustic traditional looking walls.
Add one or two dry linen glitter pots for one finishing plaster bucket MA TERRE PREMIERE depending on the desired effect.
Ready to use.
Conditioned 100Gr pot
Colour: natural
Shelf life: illimited
Flax straw100% natural et biodégradales.
FLAX STRAW
*Information sur le niveau d’émission de substances volatiles dans l’air intérieur, présentant un risque de toxicité par inhalation, sur une échelle de classe allant de A+ (très faibles émissions) à C (fortes émissions).
Made in France and only made of clay and sand, plasters MA TERRE PREMIERE ® can be applied on interior walls in every room of your home, office or shops.
You will bring your home a natural alternative to conventional building materials.
Ready to use.
Packed in 25 kg pot
Available in 9 colors.
Cover 25 kg + - 10 m2 in 2-3 mm thickness .
Shelf life : unlimited
Drying time: A few days depending on thickness and Ambient temperature
CLAY PLASTER FINISHES ( Top coat )
*Information sur le niveau d’émission de substances volatiles dans l’air intérieur, présentant un risque de toxicité par inhalation, sur une échelle de classe allant de A+ (très faibles émissions) à C (fortes émissions).
Clay basecoat plaster for inside use only.
Used to prepare rough walls like brick walls, croncrete walls, stone walls...
You will bring your home a natural alternative to conventional building materials.
Ready to use.
Packed in 45 kg pot
Cover 45 kg + - 5 sqm in 8 mm thickness .
Shelf life : unlimited
Drying time: A few days depending on thickness and Ambient temperature
CLAY BASECOAT PLASTER
Our clay basecoat plasters
-Mix the clay basecoat bucket with water.
Adjust water depending on the desired creaminess. Let stand 10 minutes then re-mix. The mixing can be done by hand or with an cement mixer.
-Apply the clay basecoat plasters with a trowel or a big steel trowel ( from 4 to 10 mm) in order to minimize all the irregularities of the support .
-Apply with your hand the Fibreglass Mesh or the burlap flap inside the fresh clay basecoat to reinforced your plaster.
Equalized but keep a rough texture like sand paper.
Let it dry
-Mix-your bucket top coating clay plaster with 4 liters of water minimum. Adjust water depending on the desired creaminess. Let stand 30 minutes then re-mix. The mixing can be done by hand or with an electric mixer.
- Apply the plaster with the stainless steel trowel in a thickness of 2-3 mm. Equalize thickness.
Clay is a 100% natural product, it may contain a few small grains that can be simply removed with your finger when applying.
- After partial drying (The plaster is no longer sticky) Compress the plaster with the plastic trowel to assure a well bonded surface by compacting the aggregates in the clay together as one surface. and let dry for a few days depending on the ambient temperature.
HOW TO USE?
2
Applying our clay plasters finishes
1
Applying our clay basecoat plasters
Clay plasters hang on wall naturally. The subtrate need to be rough.
Clay basecoat plasters MA TERRE PREMIERE ®
+
Burlap flap or Fibreglass Mesh ( To solidify the plaster )
+
A bucket of clay plaster MA TERRE PREMIERE ®
+
A stainless steel trowel, a plastic trowel, a plaster trowel.
Materials and tools :
Recommended substrates :
All "rough" substrates like clay walls, hemp concrete, stones, bricks, concret blocks, concrete plasters, clay bricks, compressed earth blocks, hemp & clay walls...
acide phosphorique cire autolustrante cire de finition cire naturelle cire terre cuite decapant-terre-cuite detachant huile detachant terres cuites detachant terres cuites graisses décapant surpuissant dégraissant carrelage dégraissant terres cuites emulsion cire dure enlever tache de graisse terre cuite enlever tache huile entretien-terre-cuite entretien-terre-cuite-cailleau-tomettes entretienterrecuite entretien terres cuites hydrofuge-terres-cuites hydrofuge oleofuge impermeabilisation-des-tomettes imperméabiliser tomettes laitances carrelage laitances terres cuites nettoyant naturel terres cuites nettoyer carrelage nettoyer les taches nettoyer tomettes peinture terre cuite protection terres cuites proteger mes terres cuites raviver terres cuites siccatif tache graisse terres cuites protegees tomettes anciennes Ademe, Adobe, Agence, Aggloméré (liège), Aides, Anah, Ampoules, Argile (enduit), Architecte, Architecture bioclimatique, Architecture intérieure, Artisan, Artisanat, Association, Auto construction Carrelage de Saint Samson est spécialisé dans la fabrication de carrelage à l'ancienne, de terre cuite à l'ancienne terre cuite artisanale, rénovation de carrelage...
Tel: 03 44 82 40 22 Fax: 03 44 82 74 69
4, rue de la briqueterie
Copyright © 2014 CARRELAGES DE SAINT SAMSON all rights reserved
CARRELAGES DE SAINT SAMSON
• 60220 • SAINT SAMSON LA POTERIE • FRANCE
Email: info@carrelages-de-st-samson.com
